CFxD 2.17.5 — Automatic Mesh Refinement and Combustion Radiation

CFxD 2.17.5 introduces automatic refinement controls for narrow gaps and curved surfaces, adds P1 radiation to methane–air combustion, and improves mesh-generation reliability.

  • Automatic gap refinement: Set a minimum target number of cells across narrow gaps between nearly parallel opposing surfaces. The control works alongside local surface and volume refinement.
  • Curvature-angle refinement: Specify curvature resolution directly in degrees. Smaller angles request finer cells around curved surfaces, and decimal values are supported. New projects default to 4 cells per gap and a 16° curvature angle.
  • Mesh-size estimate: Review an approximate cell count as you adjust the global cell size. The estimate uses the geometry volume; refinement and boundary layers can increase the final count.
  • More reliable domain selection: Improved interior-point validation helps prevent the mesher from retaining the exterior region when the original seed lies too close to a wall. Generation stops if a suitable interior point cannot be found.
  • Flexible generation time: Mesh generation can continue without a fixed elapsed-time limit and remains manually cancellable.
  • P1 radiation for methane–air combustion: Include participating-gas radiation with laminar finite-rate chemistry or turbulent Eddy Dissipation combustion. Absorption and emission depend on local temperature, pressure, and CH4, CO2, and H2O concentrations, with radiation coupled to the energy equation.
  • Radiation setup validation: Case preparation checks the supported temperature range and rejects wholly transparent initial gas fills. Combustion species dialogs now use the local gas-radiation model instead of constant material radiation inputs.
  • Updated documentation: Expanded meshing and combustion guidance explains refinement settings, radiation inputs, and model limitations.

Leave a Reply

Your email address will not be published. Required fields are marked *